s6-networking
Software
skarnet.org

The s6-accessrules-cdb-from-fs program

s6-accessrules-cdb-from-fs compiles a directory containing a ruleset suitable for s6-ipcserver-access or s6-tcpserver-access into a CDB file.

Interface

     s6-accessrules-cdb-from-fs cdbfile dir

• s6-accessrules-cdb-from-fs compiles the dir directory containing a ruleset into a CDB file cdbfile then exits 0.

Ruleset directory format

To be understood by s6-accessrules-cdb-from-fs, s6-ipcserver-access, or s6-tcpserver-access, dir must have a specific format.

Depending on the application, other directories can appear in dir and be compiled into cdbfile, but s6-tcpserver-access only uses the first three, and s6-ipcserver-access only uses the last two.

The syntax for the rule name is dependent on the nature of keys, and fully documented on the accessrules library page. For instance, a subdirectory named 192.168.0.0_27 in the ip4 directory will match every IPv4 address in the 192.168.0.0/27 network that does not match a more precise rule.

The syntax for the actions, however, is the same for every type of key. A rule subdirectory can contain the following elements:

• a file (that can be empty) named allow. If such a file exists, a key matching this rule will be immediately accepted.
• a file (that can be empty) named deny. If such a file exists and no allow file exists, a key matching this rule will be immediately denied.
• a subdirectory named env. If such a directory exists along with an allow file, then its contents represent environment modifications that will be applied after accepting the connection and before executing the next program in the chain, as if the s6-envdir program, without options, was applied to env. env has exactly the same format as a directory suitable for s6-envdir; however, if the modifications take up more than 4096 bytes when compiled into cdbfile, then s6-accessrules-cdb-from-fs will complain and exit 100.
• a file named exec. If such a file exists along with an allow file, then its contents represent a command line that, interpreted by the execlineb launcher, will be executed after accepting the connection, totally bypassing the original command line. s6-accessrules-cdb-from-fs truncates the exec file to 4096 bytes max when embedding it into cdbfile, so make sure it is not larger than that.

Notes

• cdbfile can exist prior to, and during, the compilation, which actually works in a temporary file in the same directory as cdbfile and performs an atomic replacement when it is done. So it is not necessary to interrupt a running service during the compilation.
• If s6-accessrules-cdb-from-fs fails at some point, the temporary file is removed. However, this doesn't happen if s6-accessrules-cdb-from-fs is interrupted by a signal.
• After the program successfully completes, if dir was a suitable candidate for the -i option of s6-ipcserver-access or s6-tcpserver-access, then cdbfile will be a suitable candidate for the -x option of the same program, implementing the same ruleset.
• cdbfile can be decompiled by the s6-accessrules-fs-from-cdb program.