s6-linux-init
Software
skarnet.org

The s6-linux-init-hpr program

s6-linux-init-hpr triggers the software shutdown procedure, or, with the -f option, it perform an immediate hardware shutdown. It is normally invoked through halt, poweroff or reboot wrappers created by s6-linux-init-maker.

Interface

     s6-linux-init-hpr [ -f ] [ -h | -p | -r ] [ -d | -w ] [ -W ]

• If the -f option is present, the system is stopped or rebooted immediately.
• Else, the machine's shutdown procedure is started.
• The command exits 0; the shutdown procedure happens asynchronously.

This interface is the traditional sysvinit interface for the halt, poweroff and reboot programs. s6-linux-init-hpr must always be called with one of the -h, -p or -r options.

Options

• -f : force. The command will not trigger a clean shutdown procedure; it will just sync the filesystems then tell the kernel to immediately halt, poweroff or reboot. This should be the last step in the lifetime of the machine.
• -h : halt. The system will be shut down, but the power will remain up.
• -p : poweroff. The system will be shut down and the power turned off.
• -r : reboot. The system will reboot.
• -d : Do not write a wtmp shutdown entry.
• -w : Only write a wtmp shutdown entry; do not actually shut down the system.
• -W : Do not send a wall message to users before shutting down the system. Some other implementations of the halt, poweroff and reboot commands use the --no-wall long option to achieve this.

Notes

• When an administrator runs s6-linux-init-maker, the resulting directory has a bin/ subdirectory that contains halt, poweroff and reboot scripts that call s6-linux-init-hpr with the relevant option. The contents of this bin/ subdirectory should then be copied by the administrator into /sbin for full interface compatibility with sysvinit.