execline
Software
skarnet.org

The && program

&& performs conditional execution.

Interface

In an execlineb script:

     && [ -X ] [ -n ] [ -t | -x exitcode ] { prog1... } prog2...

• && reads prog1... in a block. It forks and executes it, then waits for it to complete.
• If prog1 crashes, && prints an error message then exits 128 plus the number of the signal that killed prog1.
• If prog1 exits a non-zero status, && exits 1.
• Else && execs into prog2.

Options

• -X : treat a crash of prog1 as a non-zero ("false") exit.
• -n : negate the test (exit on true, exec into prog2 on false)
• -x exitcode : exit exitcode instead of 1 if the test fails.
• -t : exit 0 instead of 1 if the test fails. This is equivalent to -x 0.

Notes

• && will exit if prog1... exits false. To use it in an execline script that must run prog3... no matter the result of the test, use a ; wrapper:

   ; { && { prog1... } prog2... } prog3... 

  (in execlineb syntax)
• && prog1... "" prog2... is equivalent to sh -c 'prog1... && exec prog2...'.